Contact
Turbo vacuum pump is a rotary vane vacuum pump applied to vacuum systems in papermaking, chemical, metallurgical and other industries. With advantages of large pumping capacity, high efficiency, no working fluid required and no corrosion or scaling on equipment, it serves as an alternative to positive displacement vacuum equipment.

Precautions for Using Turbo Vacuum Pumps
Turbo vacuum pumps take gas as the working medium. Liquid boasts much higher density and viscosity than gas. Especially when the centrifugal impeller runs at over 20000 r/min, liquid exerts far stronger force on the impeller than gas. If liquid exists in the gas medium, rotor balance will be easily disrupted, triggering severe failures such as fractured impeller blades and bent main shafts. Repairs cost massive labor and materials, and equipment shutdown severely interrupts papermaking production. In conventional processes, vacuum pipelines at the wet end of paper machines carry mixtures of gas, liquid and impurities with insufficient separation, most of which flow straight into vacuum equipment. Therefore, strict inlet control is required to stop liquid water from entering the turbo vacuum pump unit.
1. Turbo vacuum pumps operate at high rotating speeds within vacuum systems. Multi-stage units normally run at 5000 r/min, while single-stage units exceed 10000 r/min. A heavy-duty foundation is necessary for the whole unit to eliminate high-frequency vibration.
2. Single turbo vacuum pumps feature high power output. Startup and shutdown cause load fluctuations on the power grid, so a time interval must be reserved between starting different units. Before each startup, the motor protection program checks whether the shutdown duration meets the specified interval requirement.
3. Ultra-high impeller rotating speed raises strict standards for machining and installation precision, so high-precision dynamic balance testing under high speed is mandatory for impellers.
4. A large concrete vacuum separation tank must be equipped to intercept entrained moisture and foreign debris, partitioned by stainless steel plates. The maximum air velocity inside shall not exceed 3m/s.
5. Complete pipeline cleaning is required after pump installation to eliminate residual debris that may damage the unit.
6. Air generates loud noise during acceleration, compression and expansion. Turbo vacuum pumps are normally installed in fully enclosed rooms during design and erection to contain noise spread.




